Community R.35COAX Instructions d'exploitation télécharger pdf (Page 7)

R.15COAX, R.35COAX, R.35-3896 Installation and Operation Manual Page 7

Figure 3. Mount the loudspeaker to the yoke

MOUNT THE LOUDSPEAKER

The factory yoke uses threaded studs and a nut / lock

washer / at washer combination rather than bolts. This

makes it easier to attach the loudspeaker to the yoke after

the yoke is mounted to the support structure.

q Attach the loudspeaker to the yoke. See Figure 3. Screw

an 8mm stud into each side of the loudspeaker so that it

protrudes about 3/4" (19mm). Place the rubber washers on

the studs and then lift the loudspeaker into place between

the yoke arms. Attach as shown. Support the enclosure until

both sides are secured. Tighten bolts to nger tight (enough

to hold the loudspeaker in position).

q Determine the approximate angle of downward tilt. It

must be angled at least 5° down from horizontal to maintain

the stated enclosure IP55 rating. Tighten the hex nuts until

sufciently tight enough to hold the angle.

IMPORTANT: The loudspeaker is not designed to be

rotated 90° or mounted upside-down. Doing so may cause

water pooling in the safety cable recess, compromising

rigging safety and performance, and may void the product

warranty. Pan-tilt and full rotation yokes are available for

multi-angled and down-re applications.

Attach safety cable here

Figure 4. Attach the safety cable

R.35

R.15

ATTACH SAFETY CABLE

q Attach a safety cable to the integrated eyebolt on the

rear of each loudspeaker (see Figure 4). The safety cable

and hardware are not included. Please consult a structural

engineer for the appropriate cable for the load and

application. The safety cable must be secured to a suitable

load-bearing point separate from the loudspeaker mounting

point, with as little slack as possible, so as not to develop

undue kinetic force if the R-Series mounting were to fail.

8 x 32 mm SS Stud

(leave 3/4" sticking out)

2" OD

Rubber Gasket

Enclosure

8mm SS Lock Washer

8mm SS Flat Washer

Yoke

8mm SS Hex Nut

R.15

8 x 32 mm SS Stud

(leave 3/4" sticking out)

2" OD

Rubber Gasket

Yoke

Enclosure

8mm SS

Hex Nut

8mm SS

Lock Washer

8mm SS Flat Washer

R.35

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Community R.35COAX Instructions d'exploitation Page 7

Commentaires sur ces manuels